Author Topic: Michaels engineering epoxy pump  (Read 7460 times)

Offline larspa

  • Third Mate
  • *****
  • Posts: 637
    • Email
Michaels engineering epoxy pump
« on: February 12, 2008, 07:19:41 AM »
Anyone have a Michaels engineering epoxy pump that they'd like to sell?
Jumbo 24' in progress.

Offline Frank Olsen

  • Boson
  • ****
  • Posts: 292
Re: Michaels engineering epoxy pump
« Reply #1 on: February 15, 2008, 11:09:04 PM »
Or two. I need one too.

Frank
Frank

Offline luk diver

  • Chief Officer
  • ********
  • Posts: 1279
    • Email
Re: Michaels engineering epoxy pump
« Reply #2 on: March 28, 2008, 06:38:18 PM »
Haven't been looking much lately but Michael Eng. has marketed 'used' and 'rebuilt' pumps on eBay in the past. Peerhaps try touching base with them? Our pump ended up with Steve and can't remember IF he sold it onto Adam. They certainly go around. Bob

Offline guldam

  • Administrator
  • Chief Officer
  • *****
  • Posts: 1404
    • Fishyfish.com
    • Email
Re: Michaels engineering epoxy pump
« Reply #3 on: April 06, 2008, 08:12:07 PM »
Long story... I had it sold, then I wigged out on getting it packed up. Then had it sold again, and the feller never followed through. So I still have the pump sitting in the garage. Needs a rebuild kit as two boats have been built on it, and the hardener side stopped pumping at the end of my project. It's been cleaned up best as I can and needs a box built for it for shipping. IF local then it comes with Bob's wheeled and heated cart.

steveoh

Offline tananaBrian

  • Captain
  • *********
  • Posts: 2920
    • Glacier Boats of Alaska
    • Email
Re: Michaels engineering epoxy pump
« Reply #4 on: April 18, 2008, 06:38:41 PM »
Long story... I had it sold, then I wigged out on getting it packed up. Then had it sold again, and the feller never followed through. So I still have the pump sitting in the garage. Needs a rebuild kit as two boats have been built on it, and the hardener side stopped pumping at the end of my project. It's been cleaned up best as I can and needs a box built for it for shipping. IF local then it comes with Bob's wheeled and heated cart.

steveoh

I rebuilt mine ...it wasn't hard.  You have to be careful getting the o-rings off the little pump thingies, but it's not hard.  Just use a bright light and reading glasses (if your eyes are as bad as mine that is.)  I'd buy a used pump and rebuild it with no second thoughts at all...

bd

The Great Alaskan - Professional performance - Easy to build! - https://www.glacierboats.com  ><((((º> ¸.·´¯`·.¸¸><((((º> ¸.·´¯`·.¸¸><((((º> ¸.·´¯`·.¸¸><((((º>

Offline Randy Zimmerman

  • Third Mate
  • *****
  • Posts: 646
Re: Michaels engineering epoxy pump
« Reply #5 on: July 19, 2012, 06:18:33 PM »
does anyone have a Michael's pump they would like to sell?

Randy
Saltwater Workshop Kit
21'4" Widebody
Start:1 June 2013
Flip: 9 April 2014
Maiden Voyage: 22 May 2015