Author Topic: Bottom molds/saddle spacing on a 24’ jumbo  (Read 97 times)

Offline MattRabasco

  • Swabbie
  • *
  • Posts: 7
Bottom molds/saddle spacing on a 24’ jumbo
« on: January 14, 2022, 06:41:37 PM »
Hey everyone, I’m about ready to stitch the bottom panels together on the 24’ Tolman build.  Does anyone know the right position for the 2 molds/saddles?  The book has measurements for the 20’ but not the 24’.  Thanks in advance!  - Matt

Offline wildscottishblum

  • Deckhand
  • **
  • Posts: 96
    • Email
Re: Bottom molds/saddle spacing on a 24’ jumbo
« Reply #1 on: January 14, 2022, 07:04:26 PM »
The additional length of the hull is all in the straight run aft. Use the spacing in figure 12-3 and then extend the rear spacing, can even add a cradle if you want.
I took a lot of pictures but my notes are limited so I don't have the spacing I used.

Offline TFreeburg

  • Boson
  • ****
  • Posts: 372
Re: Bottom molds/saddle spacing on a 24’ jumbo
« Reply #2 on: January 15, 2022, 08:30:38 AM »
I agree with WildScotishBlum
Snohomish Tom
My goal: 25' Jumbo
First epoxy: 10/3/17
Flipped: 6/15/2019