Jallii! You've been pretty quiet! Im getting close. Minor set back with the engine harness... turns out that my 'new' engine was old enough to have the old 8-pin not the new 14 pin harness, so I had to order an adaptor. And also there is a difference between gen1 and gen2 merc cables. And no adaptor kit. But there is a uflex k35 adaptor that works the B185 console mount box for gen1's... we went through all of the mercury console mount boxes but none of them fit because I used the CLC peeler console measurements and its too narrow at the top, for anything but this uflex guy. I should have known something was up when I noticed that CLC actually sells the uflex box. Next time I make one of these consoles, I will widen it enough to get a mercury box to fit.
