I screwed up and didn't get my chines butted perfectly. I ended up with one being off just a bit at the joint and it has thrown the chines out of line.

 

 

You don't have to be off much to really throw things out of whack!

 

 

 

 

 

 

 

 

After calling Neal and soliciting input from the Tolman forum I learned it is not a disaster and I can simply cut the bad chine and reglue when it is applied to the bottom panel. Actually I got the cart before the horse on this and should have waited until it was time to apply to the bottom panels anyway. Duh!

Nov 12, 2005

 

---