Today was a good day I first measured and cut the framing members on the port side. This took multiple measures. Not only from today but from previously because both sides of the the framing members should have been measured and placed earlier together. But since I have so little room to work with (as explained previously) I had to do the sides seperately.
Once the framing members were placed the port side panels were prepped to go on. They had been glued up at the scarfs earlier and today were laid up and screwed to the side, then marked, taken off and cut.
Once that was done they were then glassed on the inside of the panel.The next morning I sanded all the edges in order to have a good glue-up connection to the framing.
Feb 18, 2006
Port panels prepped .
